Tag Archives: printer

TeamViewer: Remote Print

To activate the remote printing function, follow these steps:

  • In the Remote Control window, click Extras | Remote printing during a session.  The TeamViewer printing dialog box will open.
  • Click the Continue button. On the remote computer, the TeamViewer print driver will be installed. This only has to be done once.
  • You have now successfully activated remote printing. All printers available on the local computer can be used by the remote computer, too.
  • Once TeamViewer remote printing has been activated, the printers available to the local computer can be selected in the print dialog boxes and control panel on the remote computer. TeamViewer remote printing printers are labeled with via TeamViewer.

To run a print job, follow these steps:

  • Open the document you would like to print on the remote computer.
  • Open the Print dialog box.
  • Select a printer ending with via TeamViewer.
  • Start the print job.
  • The document will print out on the selected printer at the local computer
  • This is from the Teamviewer 8 Manual

Mac: Duplexing Options

To turn on the duplexing (or to check and see if it’s already on):

  1. Go to:  Apple -> System Preferences -> Printers & Scanners
  2. Select your printer from the left and click on “Options & Supplies”
  3. Click on “Options” on the top tab
  4. Make sure Duplexer is checked (see below)

To print on both sides of the paper in Microsoft Word:

  1. Open the document and go to:   File -> Print
  2. Change “Copies & Pages” (third option down) to “Layout”
  3. Change “Two-Sided: Off” to “Two-Sided: Long-Edge binding”
  4. Click “Print” to print

HP Printer: 10.92.00 Cartridges Not Engaged

  1. Open and then close the front door.
  2. Make sure all the print cartridges are seated correctly.
  3. Inspect each cartridge for broken parts. if so replace the cartridge
  4. Inspect each cartridge lock-lever (on the right side). Open the front door and remove all cartridges and the ETB. Then use the ETB holder on the right side to move the lock-levers up and down. Replace the cartridge lock if it is broken.
  5. Inspect the right side cam. This piece controls the movement of the cartridge engagement arm, the cartridge shutters, and the OPC drive. You can inspect this piece without taking off the covers by wiggling the white rod arm on the right side of the ETB. If it moves easily, the part is broken and should be replaced.
  6. Inspect the ribbon cables. Folded or damaged ribbon cables can cause a short that generates an error.
  7. Inspect the cartridge guide rails to see if any are damaged.
  8. Upgrade the DC controller firmware.
  9. Clean the contacts on the memory controller PCA.
  10. On the DC controller, make sure that connections are seated correctly.
  11. On the driver PCA, make sure that connections are seated correctly.
  12. Check the gears on the print-cartridge drive motors. Replace defective motors.
  13. Replace cartridge drive